Fabrication for Care

Interdisciplinary Project Winter Semester 2018/2019
Rhine-Waal University of Applied Sciences FabLab Kamp-Lintfort
by Adriana Cabrera, Prof. Karsten Nebe, Prof. William Megill
Faculty Enviroment and Energy

3D Printing

in the following presentation you can find the Presentation of 3D Printing

3D Scanning

in the following presentation you can find the a short introduction of 3D Scanning and Meshmixer

Assignment for this week

  1. Print the joint of the last week
  2. Make your own 3D scanning
  3. Clean your 3D scan and explore the tools of Meshmixer
  4. Install the Software Exact Flat
    5. FabLab Kamp-Lintfort
Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.